Automobile lecture hall: tell you which driving skills are unsafe

These driving methods, such as fast shifting and neutral sliding, are normal for ordinary car owners. However, some driving methods are no longer suitable for the more technical models now, and some old habits should be changed.

1. Quick shift

There is nothing wrong with fast shifting. The key is that many owners start shifting together at the same time, and the older the owner, the more bad this is. It is a wrong habit to think that it can save fuel and be good for the engine. Each car has a reference speed for shifting. The throttle should be increased to make the vehicle reach a certain speed before shifting, and now the design of the engine generally uses high speed as a reference value. If the low speed shift is not well coordinated, the vehicle is easy Turn off and tremble.

2. Driving in neutral

In today's high oil prices, the use of neutral Gear to achieve fuel saving is a common method for car owners. In fact, whether automatic or manual gear vehicles, neutral sliding will not only save fuel, but may cause serious consequences. Most cars now use electronic fuel injection systems, and for safety reasons, manufacturers did not consider the situation of neutral sliding at the beginning, so in fact, the vehicle is in an abnormal operating state in neutral. At this time, the clutch and gear will also increase wear, so not only can not save fuel, but also lay hidden dangers to driving safety.

3. Half clutch

When you first learn to drive, the most common thing is to step on the clutch to the end and then slowly release it. However, some skilled car owners believe that such a time-consuming start-up often puts them in gear, stops or starts in a semi-clutch state, and it will accelerate the aging of the clutch after a long time. In a half clutch, the active and passive plates of the clutch will be in a slight friction state for a long time, which will cause the clutch to heat up, and the high temperature will damage the clutch. At the same time, it will also accelerate the wear of the pressure plate, separation bearing and other components. Owners are better not to be lazy, try to step the clutch as low as possible.

4. With brakes in corners

Deceleration when cornering is absolutely safe driving, but many car owners like to leave the braking process in the corners. In fact, they should apply the brake before entering the corner and the accelerator after entering the corner. Stepping on the brakes when crossing a curve will cause the brakes in the front, back, left, and right sides to wear to varying degrees. Over time, the vehicle will tremble when braking, affecting the balance of the vehicle. If the direction and braking force are not properly controlled, it may cause an accident.