Core Tip: When disassembling the gear oil pump, each part should be preserved. Special attention should be paid to the explosion-proof surface of the explosion-proof parts. The insulation should not be damaged, including the insulating gasket and casing. If it is damaged, it must be replaced with the new one. Parts shall not be replaced with substitute materials that are lower than the performance of the raw materials or parts that do not conform to the original specifications. Introduce the maintenance of some gear oil pumps should pay attention to: 1. Save each part and exchange the same parts. When disassembling the gear oil pump, each part should be preserved. Pay special attention to the explosion-proof surface of the explosion-proof parts, which can not damage the wool, including the insulating gasket and casing. For damage, the same new parts must be replaced. Substitute materials that are lower than the performance of the raw materials or parts that do not conform to the original specifications shall not be used. All parts shall be assembled in the original position during assembly and shall not be missed. 2, often fatliquoring, electric drum pump for high-speed operation, grease is easy to volatilize, so the lubrication at the bearing must be kept clean, and pay attention to add. 3, pay attention to save the electric pump should be placed in a dry, clean and non-corrosive atmosphere. 4, gear oil pump often check maintenance, electric oil drum pump should be checked frequently, maintenance, must check the power cord: internal wiring, plug, switch is good, insulation resistance is normal, brush tail seat is loose, commutator and brush Good contact, whether the armature windings the stator windings are suitable for interrupting the road, whether the bearings and rotating parts are damaged, etc. 5, gear oil pump pay attention to insulation resistance, long-term use of electric pumping pump used or used in humid environment, the insulation resistance of the winding must be measured with a 500 volt megger before use. If the insulation resistance between the winding and the motor casing is less than 7 megohms, the winding must be dried. Concerned about surprises Label: Maintenance of gear oil pump Previous: How to use the hot oil pump Next: Structural improvement and strength calculation of the plug valve Stone Fixing System,Marble Fixing Systems,Marble Fixing Anchor,Cladding Fixing System Taizhou Risco Stainless Steel Products Co.,Ltd , https://www.riscofastener.com