1, laying the floor is recommended to choose the brand floor, the thickness is best around 0.8, too thick heat transfer is not good, not energy-saving, brand floor environmental indicators are relatively high, so do not have to worry about harmful gases. If you find odor, you should stop power in time Use, timely and accurate identification of the reasons, timely processing to ensure safe use. 2. It is strictly forbidden to place objects that are not conducive to heat dissipation at the contact position of the thermostat. Otherwise, the temperature control will be inaccurate, and the temperature of the whole electric film will be unbalanced. (The contact position has a covering, and the heat is not collected under the covering. The temperature has been reached to the set temperature (such as 30 `C), and the other areas of the film have not actually reached the set temperature of 30 ° C. 3. On the floor of the far-infrared electric heating film, do not make fixed decoration or place legless furniture as much as possible (if there is no leg furniture, you can consider giving it out) to prevent local heat dissipation from being unobstructed. The quilt, the cushion and the like, or the quilt, the temperature under the cushion will overlap, gather heat, produce high temperature, and will damage the membrane and the floor. 4, the normal use recommended to set the temperature below 35 degrees, the first temperature rise or use for a long time does not start to start from a low temperature start, 15-20 degrees low temperature operation for a period of time, after adjusting to the ideal set temperature. 5. It is strictly forbidden to lay flame-retardant objects on the heating surface of the electric heating film. It is strictly forbidden to nail nails on the floor tiles of the paved electric heating system. Keep the floor or floor tile on the electric heating film clean. Do not leave debris, sharp wood chips, nails, etc. on the electric heating film to avoid damaging the electric heating film. 6, the ground must be covered with insulation layer, the northern cold area (or the first floor) can consider increasing the thickness of the insulation layer, so the effect will be better. The laying of floor tiles should be made by thin-ply technology. The mortar cement should be around 3-4CM. The moisture of the mortar should not be more than the electric heating film should be placed in the plastic bag. 7. Turn off the floor heating or low temperature setting when going out or no one in the room. A thermostat should be provided in each room. The thermostat should be placed on an easy-to-operate interior wall and should not be placed in a sheltered or cold wall or in direct sunlight. The temperature controller should choose the temperature control accuracy, the control area should be larger than the area of ​​the electric heating film, and the contact should be attached to the back of the film. 8. The floor insulation layer of the steaming room is recommended to use Korean imported insulation cotton (strong fire resistance) to avoid using the squeezing plate. When used in a steaming room, the energy cloth is not allowed to be directly applied to the surface of the electric heating film, or used at the bottom part of the leg. 9. If the electric heating film uploading strip (copper sheet) is damaged (turned on or broken), it will cause sparking, so care should be taken when transporting and installing this part. Freestanding Tub Faucet,Freestanding Bathtub Faucets,Free Standing Bath Tub Faucets,Freestanding Waterfall Tub Faucet JIAHAOJIA SANITARY WARE INDUSTRY CO., LTD. , https://www.gagalfaucet.com