Roofing/Heating/welding torches Long Handle Heating Torch,BBQ LPG Flame Gun,Wholesale Long Gas Torch Shangqiu Zhengtu Hardware Technology Co,.Ltd , https://www.zlztlighter.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Revision method for closing shaft hole Correction method for closing the shaft hole
(1) Detect the wear depth of the shaft hole; if the wear depth is less than 4 mm in the diameter direction (ie, the radius direction is less than 2 mm); use the power tool to polish the part to be repaired. Pay attention to: the outer surface should not be polished too much; the rougher the better. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
(2) Use the Keisin 1755 scavenger to remove the outer surface of the bearing hole.
(3) Apply a thin layer of Kesaixin 1731 release agent on the outer ring of the bearing; in order to facilitate the disassembly of the bearing in the future.
(4) Manufacturing 2311 antifriction repair agent.
(5) Apply the repairing agent directly to the outer ring of the bearing; but only apply to the rear half of the outer ring of the bearing. The amount of coating should ensure that there is no glue between the outer ring of the bearing and the shaft hole; The gap is completely filled.
(6) Push the bearing coated with the repair agent into the shaft hole.
(7) Wipe off the extruded repair agent. Again, when pushing the bearing, make sure that the repairing position is not lacking in glue.
(8) Position the bearing.
a. The simplest method is to install the shaft together with the bearing; after the accuracy is determined, the repair agent is cured in this direction.
b. Conditions can be used; can be positioned or installed by three-point gasket positioning method or manufacturing fixture.
(9) It can be put into use after it is completely cured.
Recommend to friends comments close window Bearing related knowledge Industrial INA self-aligning ball bearings "protection strategy" large inventory of damage caused by counterfeit bearings
PY160C motor grader transmission input bearing damage treatment bearing internal structure low noise bearing selection tips
This article links to http://
Please indicate the bearing network http://
Previous:Seven Mistakes in the Application of Smooth Grease in Bearing Repair: The Common Bearing Wear and Causes
Correction method for closing the shaft hole
Source: China Bearing Network Time: 2013-07-16