Y Strainer,Y Strainer Valve,Flanged Y Strainer,Stainless Steel Y Strainer Wenzhou Dico Valve Technology Co.,Ltd. , https://www.dicovalves.com
Instructions
1, determine the lighting installation location (the lamp is only suitable for steel pipe lifting), the interface is a standard G3/4 pipe thread;
2. Use a screwdriver to unscrew the locking screw with the “unlock†mark on the plug-in box;
3. After the upper body of the plug-in box of the lamp is pulled out, rotate it directly to the threaded port of the hoisting steel pipe, and then firmly fix the upper body of the plug-in box with the steel pipe with the set screw;
4. Insert the three-core cable from the steel pipe into a plug-in box, set a length of 150mm, and then use the internal pressure line device of the plug-in box. Use a screwdriver to tighten the screw and press the cable tightly.
5. Strip the remaining cable insulation cover approximately 60mm. Use a screwdriver to connect the red wire to the “L†terminal. Connect the blue wire to the “N†terminal and the yellow-green wire to the ground wire.
6. Connect the lamp body with the lower body of the plug-in box to the upper body of the plug box that has been firmly fixed to the steel pipe, tighten the locking screw, and fix the lamp;
7. When replacing the bulb, first open the 2 flips in the middle of the lamp, open the front cover, unscrew the old bulb, replace with a new bulb, and then restore the lamp.
Precautions
1. When installing, install the lamps in the equipped carton and install them for protection.
2. When replacing the bulb, try to use the same type of bulb; if you change the bulb type or power, you should replace the matching ballast accordingly.
Anti-glare suspension lamp usage and precautions
Anti-glare suspension lamp is widely used in all kinds of factories, workshops, stations and large facilities, venues and other places for flood lighting.