Carbon Steel Caps,Carbon Steel End Caps,Carbon Steel Pipe Caps,Carbon Steel Weld Caps Cangzhou Youlong Pipe Fitting Manufacturing Co., LTD , https://www.youlongpipe.com
Phenomenon 1: Left or right. Causes: 1. The control hole on one side of the air cap is blocked and the air cap is damaged. Countermeasures: 1. Clean the atomization cap 2. Replace the atomization cap. Phenomenon 2: The center of spray is too thick. Reasons: 1. Spray coating viscosity is too high 2. Spray pressure is too low 3. The nozzle diameter and thimble increase and decrease due to wear. Countermeasures: 1, reduce the viscosity of the paint 2, increase the spray pressure 3, replace the nozzle set. Phenomenon three: spray splitting. Reasons: 1, coating viscosity is too low 2, spray pressure is too high 3, the fan control hole diameter is too large 4, the paint is not enough 5, atomization air channel blockage. Countermeasures: 1, increase the paint viscosity 2, lower the spray pressure 3, replace the nozzle set 4, add enough paint 5, clean the air channel of the denitration spray gun
Denitration Spray Gun Common Faults and Solutions
Frequent failures and solutions of denitration spray guns Denitrification spray guns sometimes have problems in the process of their use. Now we will analyze the phenomenon of denitrification spray guns in detail, and analyze the causes to find solutions. Here are some examples of common faults and how to solve them. We hope to help you: